ScanLibraryEditor
Posted: Fri Mar 11, 2016 5:28 pm
Hello everybody,
i have got a Little Problem with my moving head Prisma
it is a led Moving head and on channel 13 there is a rotating Prisma
dmx value 0-7 open
dmx value 8-134 Prisma on
dmx value 135-255 Rotation
the Problem is the moving head does not activate the Prisma when i push the button for "Prisma on"!
i always have to activate rotating Prisma first, then the Prisma appears and rotates. then i can activate the button for Prisma without Rotation and the rotating stops. as soon as i use ´the button for open, the button for Prisma on without Rotation does not work any more and i have to select Prisma with Rotation again first.
i found out when i use the faders and slowly go from dmx value 0 to dmx value 8 the Prisma apears normaly.
so the Problem might be, that when i push the button for Prisma on the dmx value jumps directly to dmx value 134, and the moving head does not like that.
i made the moving head Profile in scanlibrary Editor myself and what i tried then was to set the Default value for Prisma on to dmx value 8. but no matter where i put the fader next to the "Prisma on" function the button always sets the dmx value to 134.
i tryed to make new Shows and patch the moving head new after reprogramming the Profile but nothing worked.
i added a button "no function" with dmx value from 100 - 134 and then everything worked perfect. but i dont like the no function button in my page!
i also tryed to set the "Prisma on" function to proportional and to step mode but this also did not work!
what can i do to set the Default dmx value for the Prisma on button to 8 ???
thank you for your help
regards Patrick
i have got a Little Problem with my moving head Prisma
it is a led Moving head and on channel 13 there is a rotating Prisma
dmx value 0-7 open
dmx value 8-134 Prisma on
dmx value 135-255 Rotation
the Problem is the moving head does not activate the Prisma when i push the button for "Prisma on"!
i always have to activate rotating Prisma first, then the Prisma appears and rotates. then i can activate the button for Prisma without Rotation and the rotating stops. as soon as i use ´the button for open, the button for Prisma on without Rotation does not work any more and i have to select Prisma with Rotation again first.
i found out when i use the faders and slowly go from dmx value 0 to dmx value 8 the Prisma apears normaly.
so the Problem might be, that when i push the button for Prisma on the dmx value jumps directly to dmx value 134, and the moving head does not like that.
i made the moving head Profile in scanlibrary Editor myself and what i tried then was to set the Default value for Prisma on to dmx value 8. but no matter where i put the fader next to the "Prisma on" function the button always sets the dmx value to 134.
i tryed to make new Shows and patch the moving head new after reprogramming the Profile but nothing worked.
i added a button "no function" with dmx value from 100 - 134 and then everything worked perfect. but i dont like the no function button in my page!
i also tryed to set the "Prisma on" function to proportional and to step mode but this also did not work!
what can i do to set the Default dmx value for the Prisma on button to 8 ???
thank you for your help
regards Patrick