Binary overview

[Dojec]

Hi,
what would be handy in this release, is to have an overview page to set the dipswitches on your devices.
Now I had to check first the number in the dmx table, then open the calculator in windows to transfer it to binary code, and then go to the fixture to set the setting.
If you could print the page with all settings, you could go from fixture to fixture.
So, this would make life and debugging a lot easier.

Regards.

[simonB]

Yep could be useful, especially if it were to be added to the printed patch sheet. It's been added to the suggestions list