Dry Contact is not function for STICK CU4

Touch Sensitive Intelligent Control Keypad

Moderators: simonB, nick, florent

Post Reply
macrokinetic
Posts: 1
Joined: Wed Jan 18, 2017 7:45 am

Dry Contact is not function for STICK CU4

Post by macrokinetic » Wed Jan 18, 2017 7:51 am

I using ESA2 to program scenes with trigger and stored in STICK CU4.
However, the trigger is not work for CU4.

I tried to use hardware manager to check the port trigger and it is work.
The port signal under hardware manager is correct and change from red to green when I tried to trigger.
Please help and urgent.

nick
Maxi Forumor
Posts: 284
Joined: Fri Feb 12, 2016 2:37 pm

Re: Dry Contact is not function for STICK CU4

Post by nick » Wed Feb 08, 2017 4:44 pm

Hi,

Sorry, this there was a bug in an older firmware which prevented the ports triggers from triggering scenes on the Stick-CU4. This has now been fixed in firmware version 0.94 which is available in HardwareManager with ESA2 Beta (dated 30/01/2017) available on the downloads page.

https://www.nicolaudie.com/download.htm

1) Download and install ESA2 Beta.
2) Open HardwareManager and update your firmware to 0.94.
3) Create several scenes with Port Triggers. See information here:
https://www.nicolaudie.com/manuals/#/en ... e-settings
4) Write the show to your CU4 using the Standalone screen.

You will now find that your scenes trigger correctly with the ports.

Kind Regards,

Nick.
Nicolaudie Tech Support

Post Reply