2 fixtures with same address - how to?
Posted: Mon Dec 04, 2023 2:06 pm
Hi,
I have a setup of 5 single channel projectors in this sequence 1-3-2-1-3. Well, actually, they are in a circle pattern.
How can I make a layout to reflect this? If I duplicate a fixture, I have to patch it, but I am not allowed to patch it to the same channel.
I understand that there is only a map feature in ESA Pro2, but no layout?
I need this in order to see how my scenes actually look, instead of imagining "I have two more lights here".
I have a setup of 5 single channel projectors in this sequence 1-3-2-1-3. Well, actually, they are in a circle pattern.
How can I make a layout to reflect this? If I duplicate a fixture, I have to patch it, but I am not allowed to patch it to the same channel.
I understand that there is only a map feature in ESA Pro2, but no layout?
I need this in order to see how my scenes actually look, instead of imagining "I have two more lights here".