Power + DMX
Posted: Sat Dec 03, 2016 12:50 pm
Is there a preferred adapter for injecting the 6v via the RJ-45 (Power + DMX/pin 4 &5)? My DMX LED module is a 12-24v device. Sure wish standard POE was supported on the ethernet port.
Hi,
Thank you for your question. We sell an adaptor called the RJ2BLOCK which makes it very simple to connect DMX (out) + Power (in) to the back of your Stick-DE3 or Stick-CU4. Please see attached image.
The RJ2BLOCK is not currently on our webstore. However, if you setup an account (https://store.nicolaudie.com/signin) and then message me your account email on this forum, I can create an order for you, with a payment link. At the time of writing, the cost is €18 + shipping (+vat, if applicable).
Kind Regards,
Nick.