I'm having some difficulties getting Artnet to be enabled.
I an running Sunlite Suite 2 - FC. I've followed the directions for setting artnet in the output devices.
Whenever I follow the directions by turning off auto detect and choosing artnet and closing the output device setup, I receive the following error message:
Warning Hardware Detection.
Interface found but not set up in the DMX patch
SUITE2 FC Serial: <my serial#> ip : xxx.xxx.xxx.10
What am I missing?
Also, do we have the ability to set the IP address to something we want or are we limited to 2.xxx.xxx.xxx?
Thanks..
Artnet Setup
Moderators: simonB, nick, dylan, RichterMC, florent, Ben
Re: Artnet Setup
OK, I finally got this working, with the assistance of Simon... (Thank you!)
What the manual and videos don't tell me is that I had to to have 2 items in the Output Hardware list:
The USB or USB/Ethernet Interface as well as Artnet.
My problem was self induced because I didn't look close enough at the hardware list and had put the USB Sunlite FC interface (which I don't have) in rather than the USB/Ethernet Sunlite FC (which is what I have)..
What the manual and videos don't tell me is that I had to to have 2 items in the Output Hardware list:
The USB or USB/Ethernet Interface as well as Artnet.
My problem was self induced because I didn't look close enough at the hardware list and had put the USB Sunlite FC interface (which I don't have) in rather than the USB/Ethernet Sunlite FC (which is what I have)..