Nicolaudie Architectural Forum

Hi,

I Select fixtures
Drag them to EasyTime window and Compress Them
Apply Curve effect with phasing 1 and set appropriate settings.
Press OK and everything works as expected, the fixtures light up sequentially.

Now i want to reverse the animation when the existing one finishes. So I though copy the ths bloc i just created, paste on timeline and reverse it, but.....
phasing gets ignored on a pasted block! Fixtures light up at the same time. tweaking the phasing in curves does not help.

Then I delete the pasted block and drag a new curve effect next to existing one. Same result. Phasing does not work!

I have recorded a demonstration screen capture:
http://www.youtube.com/watch?v=oxvItbSr93g&hd=1

What am I doing wrong?

Thank you.

I try to reproduce this here, but had no luck.
Could you send me your show file to Gernot.Schoofs[äät]t-online.de

Then I will try again with your setup.


Best
Gernot

I think that this was fixed in an earlier beta. If you have the same problem with the latest version, send over your show and I'll take a look

I have downloaded the software directly from the website homepage (http://www.nicolaudie.com/downloads/fil ... suite2.exe)

this is my project file. I did the same with a brand new project and got the same result.
http://ge.tt/8eawOkf/v/0

try with the beta

I found out :
If the fixtures are selected during copy/pasting the Phasing will be copied, if the fixtures are not selected when copy/pasting the Phasing will not be included.

Best
Gernot

Thank you, RichterMC, selection solved the problem!

Thanks for reporting this, we'll get it fixed very soon