Scan Library Crashes
Posted: Sun Dec 02, 2012 7:31 pm
I am restructuring the system I have install at a night club. We have 4 very generic par 64 cans.we have an ssl file for the but i need to convert into a ss2 file. I followed the instructions to a t on opening in the scan library, then save as a ss2. When i do this it pops up saying no pan/tilt channels, i say ok and all is good. or so i though. when i try to make a new page with the newly save ss2 profile it wont let me get past the profile selection window. when looking at the new file properties it says 1 kb. It looks like it doesn't like this file. But it was working for the past 4 years. i had to delete the page the pars were on to make room for new cans. any ideas on how to make it work? also when i try to open the file by double clicking on it, it open the scan library editor and the says "there was a problem sending the command to the program" then crashes. any ideas?