some issues
Posted: Wed Aug 15, 2012 6:56 pm
Hi all,
from China I've purchased 4 ww moving heads with 36x10w leds
In the Library Editor the right ssl file is located in the "MS Lighting directory", the file is called MH LED 3641.
I created my own ssl file reading the fixture manual and I assigned all the necessary channels.
When I add a new page and I choose my custom ssl file I see that in Pages I have 10 fixtures but I had choose only 2 fixtures. Why?
If I choose your ssl file (MH LED 3641) and I add two fixtures I see them correctly.
Then I noticed that with my custom ssl file and with the legacy MH LED 3641 file I can't see the chaser effect, all my 4 fixtures operates at the same time.
I would like to create a sequence effect. In the fixtures tab I see the right effect: the 1st fixture is on and the other three are off, then the first is off and the second is on....etc.
How can I send this effect to my connected fixtures?
Regards
from China I've purchased 4 ww moving heads with 36x10w leds
In the Library Editor the right ssl file is located in the "MS Lighting directory", the file is called MH LED 3641.
I created my own ssl file reading the fixture manual and I assigned all the necessary channels.
When I add a new page and I choose my custom ssl file I see that in Pages I have 10 fixtures but I had choose only 2 fixtures. Why?
If I choose your ssl file (MH LED 3641) and I add two fixtures I see them correctly.
Then I noticed that with my custom ssl file and with the legacy MH LED 3641 file I can't see the chaser effect, all my 4 fixtures operates at the same time.
I would like to create a sequence effect. In the fixtures tab I see the right effect: the 1st fixture is on and the other three are off, then the first is off and the second is on....etc.
How can I send this effect to my connected fixtures?
Regards