Nicolaudie Architectural Forum

hi

i'm working on sunlite suite 2 with the First Class + package and i am experiencing some problems using behringer BCF2000.

i have a white behringer BCF2000 limited edition with 1.10 firmware installed and only encoder wheels seems to work in sunlite studio.

slider and other buttons unfortunately doesn't work


what can i do?

Hi esapode688,

and Welcome to the Nicolaudie Sunlite Forum.

Frist you should check if MIDI Data is coming into the software.
Go to "Software Preferences" -> "MIDI setup" -> Click "Show MIDI Data".
In this window you can see all arriving MIDI messages, so use the buttons and sliders on your BCF 2000 which aren´t working and watch the MIDI-Data window.


Best
Gernot

Where did you get the name 'Sunlite Studio' from?

The reason I ask is because this was the name of a very early alpha version from about 4 years ago...make sure you're not using this!!

thank you for reply

i call this: sunlite studio because it feels like a lighting studio instead of a suite.

don't matter i have the latest version available on the site!


i checked incoming midi data; saw that all channels are wrong except for the eight encoders

for example: in sunlite suite 2 the first fader of bcf2000 is mapped as channel 85 but it's wrong!

i saw first fader incoming data on channel 81 and differently to all other faders and sliders.

so i have to remap the entire console

small correct

i used wrong word.

85 and 81 are the command on channel 1

Infact the BCF is not mapped at all by default. You can quickly re-map each console button/fader/dial by selecting the small arrow int he top right and selecting "Learn midi console preset".