Nicolaudie Architectural Forum

Hi,

I've tried quite a lot, but can't find the correct way to change the fade time between steps in a scene/swith during live mode.
To be more specific, i like transparent programming, so i only want to program the steps in a swith (or scene), assign it to my midicon console and then assign fade-time to another wheel/fader so i can adapt the fade-time DURING live play.

(This works for dimmer, speed, phase etc, but i can't find how to do this for fading)

I'm NOT looking for a way to fade BETWEEN two scenes/swiches (that's easy) :-)

Please help...

That's not possible in live, therefore I advise that you use fading between scenes/switches and put these into cycle

simonB wrote:That's not possible in live, therefore I advise that you use fading between scenes/switches and put these into cycle

So it that case it seems to be best to make a seperate switch for every step and put those in a cycle, wright?

(The idea I had originates from the "cheap" conventional consoles where you can easily change fade time using a fader, often positioned next to master and speed faders...)
It would be nice to consider this for future devellopment :-) Saves me quite some time programming

simonB wrote:That's not possible in live, therefore I advise that you use fading between scenes/switches and put these into cycle

OK, made 8 switches for 8 PAR's, put them in a cycle: now i can set fade as you suggested, but cannot change speed anymore... (do I miss anything?)

You could use the page speed dial

simonB wrote:You could use the page speed dial

This doesn't work, what am I missing:

-A have a cycle in which i plotted a few switches
-Every switch sets one PAR lamp to 255 using easyfade
-I looped the cycle

This should result in a simple PAR loop:
PAR1 PAR2 PAR3 PAR4
step 1 ON OFF OFF OFF (switch1)
step 2 OFF ON OFF OFF (switch2)
step 3 OFF OFF ON OFF (switch3)
step 4 OFF OFF OFF ON (switch4)

I tried the switch "on" and "of" (so every switch is placed twice in the cycle) and tried the "modify" functions in the cycle but that doesn't result in any working speed modification. Also tried the "enabling LIVE mode and selected "speed" option in the cycle option settings per switch in the cycle.

The cycle shows a timeline in the bottom and thats the speed it's following (realtime speed) nothing happens when i change speed dial of the page, switches, or switches within the cycle.

should i choose a setting somewhere?

Sorry I should have made it more clear that it is not possible to change the speed of a cycle.