Cannot get RGB Laser to work
Posted: Sat Jul 09, 2011 5:43 pm
I have the user manual. The laser has multiple modes which is controlled by channel one. All channels after that control things like color, speed, frequency etc. etc. The problem is the laser is unresponsive to every other channel after channel one.
For instance; one mode on channel one is called "wave mode". If you put it on wave mode it will start doing a liquid sky wave effect but from there you cannot modify color or anything. It is just completely unresponsive.
My two questions are; do you have any advice on what I might try? Is there a way in suite 2 to just see faders for all of the channels and then you can just control the signal being sent on each channel?
For instance; one mode on channel one is called "wave mode". If you put it on wave mode it will start doing a liquid sky wave effect but from there you cannot modify color or anything. It is just completely unresponsive.
My two questions are; do you have any advice on what I might try? Is there a way in suite 2 to just see faders for all of the channels and then you can just control the signal being sent on each channel?