A few questions regarding some of the SDK Commands
Posted: Tue Nov 13, 2007 6:07 pm
Hello,
I would be grateful if you could tell me the following regarding:
DHC_SIZEMEMORY
What is the unit of the value returned by the command, is it Bits, Bytes or ...?
What would be the formula (even with an approximate/estimated result) to find out the number of steps based on the available memory?
DHC_DMX2ENABLE
Is it safe to send this command to the interface if by mistake the IN port is still connected and live? If not, what are the options to allow me to detect that the port is actually free to be switched over?
Thanks in advance
PS: Sorry for the growing number of posts but I do not seem to be able to edit/modify/add to previous un-replied posts...
I would be grateful if you could tell me the following regarding:
DHC_SIZEMEMORY
What is the unit of the value returned by the command, is it Bits, Bytes or ...?
What would be the formula (even with an approximate/estimated result) to find out the number of steps based on the available memory?
DHC_DMX2ENABLE
Is it safe to send this command to the interface if by mistake the IN port is still connected and live? If not, what are the options to allow me to detect that the port is actually free to be switched over?
Thanks in advance
PS: Sorry for the growing number of posts but I do not seem to be able to edit/modify/add to previous un-replied posts...