Page 1 of 1
new interface instructions ?
Posted: Fri Oct 20, 2006 7:22 pm
by thomascariglia
there is not explanation how to use the second dmx
the first one it's ok
but the second no sign maybe I should push some buttons on the interfac
Posted: Mon Oct 23, 2006 2:43 pm
by Guest
We haven't finished this part of the manual, you must activate the 2nd output from controller menu -> starting parameters window -> output tab by checking the little check box on the right-side of the 1st USB-DMX interface (universe #1). This will enable the 2nd output for the universe #2.
about inerface
Posted: Mon Oct 23, 2006 3:59 pm
by thomascariglia
thank you bruno
I've never been around those parts so I didn't notice
thank you again
tommy cariglia