Hello,
We have a DINA-SR1,
We need to trigger scenes from an external computer, using either TCP-IP or UDP commands. Is this possible with this device today? If this is possible, where can we find information about it. It is not mentioned in the manual.
UDP and TCP-IP commands for DINA
Moderators: simonB, nick, RichterMC, florent, Ben
-
- Junior Forumor
- Posts: 29
- Joined: Tue Jun 14, 2022 2:47 pm
Re: UDP and TCP-IP commands for DINA
Hello Eletiope,
You can find information about the DINA Network protocol by following this link: https://eu-litterature.n-g.co/Release/s ... ontrol.pdf
You can find information about the DINA Network protocol by following this link: https://eu-litterature.n-g.co/Release/s ... ontrol.pdf
Kind regards,
Harrison Goodair
Technical Support
Harrison Goodair
Technical Support
-
- Posts: 1
- Joined: Mon Aug 12, 2024 8:12 am
Re: UDP and TCP-IP commands for DINA
Hi,
This information is great!
With regards to the SLESA-U10, it has WiFi connectivity.
1. Would these UDP commands work with the U10? If so, what would the HEX Device ID be?
2. If I am reading the pdf correctly, for the SLESA devices, the scenes would need to be programmed into the standalone mode? And as such, these UDP commands can trigger the programmed scenes even without a PC/Mac connected?
Thank you for the replies in advance.
Jimmy
This information is great!
With regards to the SLESA-U10, it has WiFi connectivity.
1. Would these UDP commands work with the U10? If so, what would the HEX Device ID be?
2. If I am reading the pdf correctly, for the SLESA devices, the scenes would need to be programmed into the standalone mode? And as such, these UDP commands can trigger the programmed scenes even without a PC/Mac connected?
Thank you for the replies in advance.
Jimmy