Power + DMX

Sunlite Touch Sensitive Intelligent Control Keypad

Moderators: simonB, nick, florent, Ben

Post Reply
heimdm
Posts: 1
Joined: Sat Dec 03, 2016 12:47 pm

Power + DMX

Post by heimdm » Sat Dec 03, 2016 12:50 pm

Is there a preferred adapter for injecting the 6v via the RJ-45 (Power + DMX/pin 4 &5)? My DMX LED module is a 12-24v device. Sure wish standard POE was supported on the ethernet port.

nick
Maxi Forumor
Posts: 282
Joined: Fri Feb 12, 2016 2:37 pm

Re: Power + DMX

Post by nick » Mon Dec 05, 2016 9:23 am

Hi,

Thank you for your question. We sell an adaptor called the RJ2BLOCK which makes it very simple to connect DMX (out) + Power (in) to the back of your Stick-DE3 or Stick-CU4. Please see attached image.

The RJ2BLOCK is not currently on our webstore. However, if you setup an account (https://store.nicolaudie.com/signin) and then message me your account email on this forum, I can create an order for you, with a payment link. At the time of writing, the cost is €18 + shipping (+vat, if applicable).

Kind Regards,

Nick.
Attachments
RJ2BLOCK-cu4.jpg
RJ2BLOCK-cu4.jpg (197.02 KiB) Viewed 2231 times
RJ2BLOCK.jpg
RJ2BLOCK.jpg (119.13 KiB) Viewed 2231 times
Nicolaudie Tech Support

Post Reply