Hi there,
I was previously able to operate my LD Touch Ulti via ESA2 on my macbook, but after updating the program, I no longer am able to communicate with the unit via the the ethernet connection (USB still works fine).
ESA2 recognizes my device under the Ethernet option, but error message occurs when clicking OK after selecting the unit from the menu.
Screen grab of error message below:
Perhaps someone can shed some light on what may be causing this issue. Thanks!
Dylan
Error Message (Unable to open the interface) - Error 14
Moderators: simonB, nick, TomHat, dylan, RichterMC, florent, Ben
-
- Posts: 1
- Joined: Sun Jun 08, 2014 1:20 am
Re: Error Message (Unable to open the interface) - Error 14
I've reproduced this. We're currently looking into it and it will be corrected in the next version.
Simon
--
Sales/Support
--
Sales/Support
Re: Error Message (Unable to open the interface) - Error 14
Has this issue been resolved, I'm seeing the same problem with the Sep 14 2015 version
Re: Error Message (Unable to open the interface) - Error 14
Hi,
Could you please post your question to the Lumidesk forum here ....
http://www.lumidesk.com/forum/viewforum ... 9f01c1a6d1
The Lumidesk support team will be able to assist you.
Kind Regards,
Nick.
Could you please post your question to the Lumidesk forum here ....
http://www.lumidesk.com/forum/viewforum ... 9f01c1a6d1
The Lumidesk support team will be able to assist you.
Kind Regards,
Nick.
Nicolaudie Tech Support