inverted shape between 2 fixture groups
Posted: Fri Nov 29, 2013 2:36 pm
Hi,
i can't find, using EasyTime, how to make opposite shape on two different fixture groups.
I explain:
1 page, 4 fixtures (scans).
I need to create a switch where scan1 and scan 2 do a clockwise circle, scan 3 and scan 4 do anti-clockwise circle (it's an example).
I've tried to affect a "Pan tilt effect (i=1)" on scan 1 and scan 2 and a "Pan tilt (i=2)" on scan 3 and scan 4 by copying them... but it doesn't work. Only scan 1 and scan 2 moves...
I looked at the editor manual... but i did not find anything about that.
Regards,
Gael
i can't find, using EasyTime, how to make opposite shape on two different fixture groups.
I explain:
1 page, 4 fixtures (scans).
I need to create a switch where scan1 and scan 2 do a clockwise circle, scan 3 and scan 4 do anti-clockwise circle (it's an example).
I've tried to affect a "Pan tilt effect (i=1)" on scan 1 and scan 2 and a "Pan tilt (i=2)" on scan 3 and scan 4 by copying them... but it doesn't work. Only scan 1 and scan 2 moves...
I looked at the editor manual... but i did not find anything about that.
Regards,
Gael