Trigger ports HE10 and motion sensor?

[pileo]

Hello,

I am an absolute beginner in electronics... Is it possible to use the trigger contacts (HE10) to use a motion sensor to trigger sunlite?

If yes, how to connect the motion sensor and the sunlite device?

Thanks!

Leo

[pileo]

Noone...? :(

[Ben]

Hi Pileo,

Yes this is definitely possible using the HE10 ports, below is a link to the relevant section of the hardware manual which has all the information you need.

http://manuals.lightingsoft.com/en/26-1 ... TE-gY7.htm

Hope that helps.

[pileo]

Hello

The manual is not available anymore. Can you please help me?

Thank you!

[peteknobloch]

To work your motion detector MUST have relay contacts that close when motion is detected. There MUST NOT be any voltage that feeds out of the motion detector. Just a switch closure from the relay. Connect the normally open relay contacts to the GND and P1 of the HE-10 port. There was a document that talked about it but my old link doesn't work anymore. Look here for a simplified connection. https://storage.googleapis.com/nicolaud ... asheet.pdf