Page 1 of 1


Posted: Tue Apr 28, 2015 6:47 am
by avecom
I want to use the Stick KE-1 to control Scanners (Cameo CLSCAN60W)
I program it with ESA Pro, but my scans don't react like I want, in the 3D easy show it looks good, but my scans only go from left to right when i try my scenes for real.
It don't changes the gobos, colors and it even doesn't pans & tilt like it should.
It looks realy stupid now the only go from left to right

I hope somebody can helps me out.
I attached a small file so you can look at it


Posted: Wed May 13, 2015 1:41 pm
by Ben
Hi there,

If you send me over the fixture profile (SSL file) you are using along with the Cameo CLSCAN60W user manual I can take a look and try and see what the problem is.