Page 1 of 1

Not lighting individually

Posted: Sun Feb 28, 2016 1:20 am
by kenm
Hi there.

I am new to this and would appreciate any help.

I have wired up the Stick 1 and a 4 channel decoder and the driver to light up a Dazzle RGB light tape with 122 lights. I would like to have them phased to simulate a bubble traveling down the strip. In the ESA Pro Beta software I was able to do with a Curve effect and I added Phasing for the motion and in the software preview it looks correct. I figured out how to connect to the controller and I see the correct colors with the curve effect on the light strip, but the lights are all operating in sync. There is no phasing.

Help please.