Stability problems when using Ports
Posted: Fri Sep 06, 2013 7:47 pm
Hi
I am using relays to generate bitcodes for triggering scenes via the 4 ports on the KU1.
Very often one scene (Bitcode 13) triggers and the lamp switches on. This without any movement on the relays. Like a ghost is starting a scene:)
Any idea why?
Maybe the ports voltage can be stabilized by putting a 10 k ohm resistor from port 1-4 and to the 6V plus?
Any other idea?
/Jan
I am using relays to generate bitcodes for triggering scenes via the 4 ports on the KU1.
Very often one scene (Bitcode 13) triggers and the lamp switches on. This without any movement on the relays. Like a ghost is starting a scene:)
Any idea why?
Maybe the ports voltage can be stabilized by putting a 10 k ohm resistor from port 1-4 and to the 6V plus?
Any other idea?
/Jan