Impossible to write memory
Posted: Fri Aug 24, 2012 6:01 am
Currently working on an architectural LED installation of 48 LED fixtures using ESA2 on Macintosh.
Tested the controller out of the box in my shop, did a test program with one fixture and uploaded it to the controller, no problems.
Arrived on site and cannot write to controller.
I can pass data through and program/playback fixtures, just cannot load to controller.
In Standalone mode using USB I see a ? using ethernet I see the controller but get the same result.
I really need to resolve this quickly.
Thanks.
-s
Tested the controller out of the box in my shop, did a test program with one fixture and uploaded it to the controller, no problems.
Arrived on site and cannot write to controller.
I can pass data through and program/playback fixtures, just cannot load to controller.
In Standalone mode using USB I see a ? using ethernet I see the controller but get the same result.
I really need to resolve this quickly.
Thanks.
-s