Nicolaudie Architectural Forum

Hi.
I have created some new shows that i wish to use tonight - New Years Eve.
However, when I try to "Write the interface memory" I get a message - "Please Add the stick name in the StandAlone Tab". I don't know what to do next............

Regards,

AndyH

If you are writing to sticks over a LAN, you must set up each STICK. Click the + icon in the stand alone panel to add a new stick, the 3rd icon along allows you to select a STICK from a list of connected STICKs.

If you are using the STICK with USB, you should not get this message.

Hi Simon,

I am writing (attempting!) over USB.

I've never had this message before.

Andy

You shouldn't have this message if you are writing over USB. Please e-mail me your show, tell me the software ver you're using and I'll take a look