Can't patch fixture after editing with Library Editor
Posted: Wed Jul 13, 2011 8:04 pm
Hi,
I'm trying to make a 'new' fixture, but I can't get it to load into Magic 3D Easy View.
I started with the file "REVO ROLL.ssl2" (an American DJ Barrel Scan) and changed the barrel to a pan/tilt.
I saved it as "REVO LED SCAN.ssl2"
When I wanted to patch it, the "Number of Fixtures"-field was blank and I coudn't add the fixture.
Tried a few times, but nothing.
Then I decided to test the Library Editor itself.
So I opened "REVO ROLL.ssl2" and immediately saved it again. Not 'Save As", just SAVE.
And what do you know? Doesn't work anymore! :-/
Any ideas?
OS: Windows 7 - 64bit
Version of Magic 3D Easy View: 30 apr 2010
Version of Library Editor: 18 feb 2011
ps: I also noticed that the file changes from 9 to 8kb in this proces of loading and saving. (don't know if it's relevant)
I'm trying to make a 'new' fixture, but I can't get it to load into Magic 3D Easy View.
I started with the file "REVO ROLL.ssl2" (an American DJ Barrel Scan) and changed the barrel to a pan/tilt.
I saved it as "REVO LED SCAN.ssl2"
When I wanted to patch it, the "Number of Fixtures"-field was blank and I coudn't add the fixture.
Tried a few times, but nothing.
Then I decided to test the Library Editor itself.
So I opened "REVO ROLL.ssl2" and immediately saved it again. Not 'Save As", just SAVE.
And what do you know? Doesn't work anymore! :-/
Any ideas?
OS: Windows 7 - 64bit
Version of Magic 3D Easy View: 30 apr 2010
Version of Library Editor: 18 feb 2011
ps: I also noticed that the file changes from 9 to 8kb in this proces of loading and saving. (don't know if it's relevant)