No dmx input
Posted: Tue May 10, 2011 7:10 pm
I recently bought Easy View 3D (including the interface). I installed this on a Windows 7 computer, but unfortunately it's not showing any light or light beams.
I have quite some experience with the older version.
I use a Showtec Light Desk Pro, linked to a rgb led spot and linked further to the interface. I checked and replaced the cables I use.
The software runs in Full mode, dmx enabled. The screen in which you can choose demo/usb/ethernet shows the usb interface option as default.
I can bind the dmx-universes to the interface. I can add fixtures. The dmx-level window is also not showing any dmx activity.
On the interface the folowing leds are active:
On the dmx-output side there's the green led is blinking fast when Easy View 3d is running, steady green if the software has stopped.
The yellow led is continuous on. The red led is blinking fast.
On the dmx-input side there's the red led blinking fast if dmx activity is present. If I disconnect the dmx cable the red led is either continuous on or continuous off.
I allready reinstalled the software and drivers, unfortunately it doesn't solve the problem.
The version of Easy View 3d is: Dec 13 2010
The interface I use has a serial nr: 153489 and firmware version 107 (Retrieved using TUSBDMX.exe)
The interface is visible in the system device manager as: Intelligent Usb Dmx Interface (SIUDI8C, 32/64bits)
Details about the installed driver: 21-10-2010, version 1.2.7.0 (Das)
In the list of installed software I find:
Magic 3D EasyView
Developper kit for USB interfaces
Driver Das (Siudi) USB (02/13/2009 1.5.1)
Driver Das (Siudi-Stick) USB (10/27/2009 1.2.0)
How can I get the software working?
With kind regards,
Jack Baltus
I have quite some experience with the older version.
I use a Showtec Light Desk Pro, linked to a rgb led spot and linked further to the interface. I checked and replaced the cables I use.
The software runs in Full mode, dmx enabled. The screen in which you can choose demo/usb/ethernet shows the usb interface option as default.
I can bind the dmx-universes to the interface. I can add fixtures. The dmx-level window is also not showing any dmx activity.
On the interface the folowing leds are active:
On the dmx-output side there's the green led is blinking fast when Easy View 3d is running, steady green if the software has stopped.
The yellow led is continuous on. The red led is blinking fast.
On the dmx-input side there's the red led blinking fast if dmx activity is present. If I disconnect the dmx cable the red led is either continuous on or continuous off.
I allready reinstalled the software and drivers, unfortunately it doesn't solve the problem.
The version of Easy View 3d is: Dec 13 2010
The interface I use has a serial nr: 153489 and firmware version 107 (Retrieved using TUSBDMX.exe)
The interface is visible in the system device manager as: Intelligent Usb Dmx Interface (SIUDI8C, 32/64bits)
Details about the installed driver: 21-10-2010, version 1.2.7.0 (Das)
In the list of installed software I find:
Magic 3D EasyView
Developper kit for USB interfaces
Driver Das (Siudi) USB (02/13/2009 1.5.1)
Driver Das (Siudi-Stick) USB (10/27/2009 1.2.0)
How can I get the software working?
With kind regards,
Jack Baltus