Easy Console help

Schadow63 · Post by **Schadow63** » Fri May 04, 2007 8:26 pm

I bought a BCF2000 to work with Sunlite Suite. Not much documentation on setting it up. I'm using small_BCF2000_10 and when I use push fader 5 on the controller it activates push fader 4 in the program. Is there a way to modify this?
I was also wondering what the other presets are for. There are 10 of them in the program but when I switch to any other than preset 1 the controller doesn't do anything.
Thanks

Post by **bruno.falip** » Wed May 09, 2007 7:20 am

You must re-assigned the fader to the correct MIDI command. Then, for the presets. You must press the "preset" button on the controller to switch to another preset.

You can read the online manual, there is a chapter about the MIDI controller.

Schadow63 · Post by **Schadow63** » Thu May 10, 2007 9:30 pm

I assume you re-assign faders with the EasyConsole tool. I see pictures of the tool but I cannot find how to start the program. None of the directions tell you how to open the EasyConsole tool.

Post by **bruno.falip** » Fri May 11, 2007 1:34 pm

You should not have to use this program to re-assign the fader, just right-click on the fader in the "Console" Window.

However, the program is located in the software installation folder.