Page 1 of 1

error 10014

Posted: Tue Aug 22, 2006 8:37 am
by Robbert

I have the following problem with the slesa-ip1, when i start ESA it recognizes the interface, when i choose ethernet mode te software still loads, but then i get the following message:

A problem occured while communicating with your interface. (10014)

It worked fine... can you help me?


Maybe wrong IP?

Posted: Tue Aug 22, 2006 10:18 am
by Robbert
I just remembered something I read in the manual:
The interface has been programmed to work on a 192.168.1.XXX network with the following subnet mask
Does this mean that it only works on an network or that it by default works on such a network? And when i change the IP to lets say networkadress it should also work?

thanks again,


Posted: Tue Aug 22, 2006 12:26 pm
by Guest
This is just a default address, you can change it of course.

Re: error 10014

Posted: Tue Sep 04, 2012 5:54 am
by brightsparks
Hi simon,
I get this message all the time.
Sometimes I can connect straight away, other times i get the " A problem occured while communicating with your interface. (SN: 3611010)"
Can you please explain as to why this message occurs.
And what I should do to do to avoid it.

I am using an IP1
IP address is factory set at
SN: 3611010
I am connecting via wireless router to the interface

What are your thoughts on this?


Re: error 10014

Posted: Mon Oct 01, 2012 4:02 pm
by simonB
Hi Mick

Apologies for the late reply. This problem typically occurs when there is a problem on the network such as a duplicate IP address or incompatible IP address settings. Try disconnecting other network devices and disabling other network devices on your computer.

Re: error 10014

Posted: Sun Apr 28, 2013 8:49 pm
by brightsparks
I have also discovered that after this message comes up, if I reset IP1 at this point, (switch it off for 10 seconds and back on) and then select the continue button, the software will start up. Usually.