Nicolaudie Architectural Forum

Hello,

I tested my new sunlite suite 2 (first class) with 3 power rack : show tec D.Pack 6 MKII

Before i used the sunlite suite (EC). I never have problems.

Now when i edit a button (scene, or switch) when i record my modification, the 3 racks are in default (all output of the racks are set to 0 ), and need to be reset.

This is only when i quit the edit page of a button.????

I put a DMX splitter bettween the interface and rack, the problem is the same.

I tested with the old sunlite, it's ok

I tested the interface (sunlite suite 2) with a little dimmer4 (Mac Mah) i don't have this poblem.

Can you help me ?

Thanks, and sorry for my bad english.

David

Hi David

Try the Suite 2 interface with the Suite 1 software. Do you still have the same problem? If yes, change the DMX timings by opening Tools.exe found in the sunlite suite 2 software directory. Try the enhanced compatibility preset.

thank you for your repply
i tested this solution (Try the enhanced compatibility preset)
the problem is the same.

you can show my oder post, because the problem si not only on the rack, oder projector flash a short time.

this is only when i modifie a scene or switch.

you can see the defaut on this vidéo
http://www.tugler.fr/SUNLITE/

thanks

(i can't test the sunlite2 interface with the sunlite1 software before next week)