RGB Leds - color calibration
Posted: Thu Jan 27, 2011 1:52 pm
Hi there,
I am playing around and exploring the possibilities of using the S.T.I.C.K. for complete residential lighting solutions, mainly using DMX LED controllers/decoders and single color and RGB strips. I am using the following 3ch DMX decoder - http://www.supersound-bg.com/product_de ... maincat=10.
Everything works perfectly with this small exception - there is a slight mis-calibration between the color shown on the screen and the actual color displayed by the LEDs. Interestingly, this difference only occurs around the yellow secondary color - 255R, 255G, 0B gives me a pale green rather than yellow, which is located further down toward red at around 255R, 100G, 0B. Other than this, all the primary and other secondary colors seem to display just fine. I tried using different fixture profiles but non seem to give me accurate color matching. I was wondering if there is a way to calibrate this?
Thanks in advance,
Boris
I am playing around and exploring the possibilities of using the S.T.I.C.K. for complete residential lighting solutions, mainly using DMX LED controllers/decoders and single color and RGB strips. I am using the following 3ch DMX decoder - http://www.supersound-bg.com/product_de ... maincat=10.
Everything works perfectly with this small exception - there is a slight mis-calibration between the color shown on the screen and the actual color displayed by the LEDs. Interestingly, this difference only occurs around the yellow secondary color - 255R, 255G, 0B gives me a pale green rather than yellow, which is located further down toward red at around 255R, 100G, 0B. Other than this, all the primary and other secondary colors seem to display just fine. I tried using different fixture profiles but non seem to give me accurate color matching. I was wondering if there is a way to calibrate this?
Thanks in advance,
Boris