ESA Stand-alone issue
Posted: Thu Dec 14, 2006 1:48 pm
Hello All!
I have set up the ESA to operate in Stand-alone, and have 8 Scenes.
In Stand Alone, the + or - buttons do not activate scene change.
If I re-enter the ESA in USB mode, then the buttons activate the scene change.
I am using the latest version of the software (20th October 06) and the ESA model is a few weeks old.
Do I need software/firmware upgrade?
Any other ideas?
I have set up the ESA to operate in Stand-alone, and have 8 Scenes.
In Stand Alone, the + or - buttons do not activate scene change.
If I re-enter the ESA in USB mode, then the buttons activate the scene change.
I am using the latest version of the software (20th October 06) and the ESA model is a few weeks old.
Do I need software/firmware upgrade?
Any other ideas?