Hi, I found out the tx & rx on the stick for long time ago and connect it to the computer serial port with successfull result.
Only problem is that the stick hangs and I have to disconnect the usb power cabel several times a day only when I have the serial port attached. Even if no commands are sent.
Then I found this video and you have probably connect it on same way?
Should I try to use a max232 between stick and computer serial port, maybe different levels crash the stick?
STICK rs-232 protocol
Moderators: simonB, nick, RichterMC, florent, Ben
Re: STICK rs-232 protocol
Hi
There is no need to use max232. You need a standard RS232 input level.
It's hard to say if this is a hardware or software problem. The best solution is to try with another STICK. Mail me your serial number and I'll arrange to have it swapped over.
There is no need to use max232. You need a standard RS232 input level.
It's hard to say if this is a hardware or software problem. The best solution is to try with another STICK. Mail me your serial number and I'll arrange to have it swapped over.
Simon
--
Sales/Support
--
Sales/Support