Syncronisation of 2 Sticks-DE3
Posted: Mon May 04, 2015 12:53 pm
I have a problem with the synchronisation of 2 Sticks-DE3
konfiguration is as follows (Firmware Sticks 1.05, iOS 8.3)
2x Stick-DE3 connected via Ethernet to a WiFi-Router
- Stick A's DMX-output is used
- Stick B only connected via Ethernet
- Mobile App runs on iOS
- On the Stick glass surface it works very well, the 2nd Stick always show same Scene etc.
- when I use the iOS app and choose Stick A (using same surface as on Stick directly), Stick B dont changes the scene as sometimes (DMX-output is ok)
- when I use the iOS app and choose Stick B (using same surface as on Stick directly), Stick A also shows the same correctly.
- when I use the iOS app and choose Stick A (using scene buttons surface), Stick B dont shows any changes (DMX-output is ok)
- when I use the iOS app and choose Stick B (using scene buttons surface), Stick B shows reactions on its display but nothins happens on Stick A nor any changes an DMX-signal.
Knowing this probelm or is it a setting fault?
regards, Thomas
konfiguration is as follows (Firmware Sticks 1.05, iOS 8.3)
2x Stick-DE3 connected via Ethernet to a WiFi-Router
- Stick A's DMX-output is used
- Stick B only connected via Ethernet
- Mobile App runs on iOS
- On the Stick glass surface it works very well, the 2nd Stick always show same Scene etc.
- when I use the iOS app and choose Stick A (using same surface as on Stick directly), Stick B dont changes the scene as sometimes (DMX-output is ok)
- when I use the iOS app and choose Stick B (using same surface as on Stick directly), Stick A also shows the same correctly.
- when I use the iOS app and choose Stick A (using scene buttons surface), Stick B dont shows any changes (DMX-output is ok)
- when I use the iOS app and choose Stick B (using scene buttons surface), Stick B shows reactions on its display but nothins happens on Stick A nor any changes an DMX-signal.
Knowing this probelm or is it a setting fault?
regards, Thomas