Nicolaudie Architectural Forum

Hi,

How can i "power" my Stick DE3 with "Power + DMX" port ?

My configuration :
StickDE3 "Power + DMX" port <==========> CT305R module Port IN <=== 12 V Input
===> RGB Strip LED

Is it possible or am i obliged to connect POWER4M module to start my STICK-DE3 ?

thanks,
VLS

Hi, you need to check a couple of things:

-pin configuration
-voltage

The STICK takes 6 volts. If you put 12v, it will eventually overheat after a few hours/days.

More information on the pin configuration can be found in the datasheet here:
http://www.nicolaudie.com/downloads/fil ... asheet.pdf