can't patch from 1.07 to 1.08

SUITE2-BC SUITE2-EC SLESA-U8

Moderators: simonB, nick, florent, dylan, Ben

Post Reply
Astey
Junior Forumor
Posts: 41
Joined: Mon May 17, 2010 10:09 pm

can't patch from 1.07 to 1.08

Post by Astey » Sat Apr 28, 2012 12:14 pm

hi,
im unable to update firmware from 1.07 to 1.08

i used 4 different computers and everytime it fails xp/w7. i hit patch firmware, the box is blinking after a while tools.exe returns with the message please patch to 1.08

its impossible to use suite2 anymore until its fixed

i use a siudi 8c

regards

simonB
SuperMaxi Forumor
Posts: 1630
Joined: Thu Sep 17, 2009 1:50 pm

Re: can't patch from 1.07 to 1.08

Post by simonB » Wed May 16, 2012 4:48 pm

With some interfaces, it's not possible to upgrade the firmware from 1.07 to 1.08. To do this, you must start in 'bootloader mode'.
-power off your interface
-create a shortcut on p2-p3-p4-GND ports
-power on your interface
-start tools.exe
-update the firmware
-power off your interface
-remove the shortcut
-power on your interface
-start tools.exe
-update the firmware again

Here is a diagram showing the ports you must connect.
bootloader mode smaller.jpg
bootloader mode smaller.jpg (41.7 KiB) Viewed 5451 times
If you don't have the correct cables for this, a quick solution is to use a ball of foil. As long as the 2 pins on the right are not connected, your interface will successfully start in bootloader mode.
bootloader_foil.png
bootloader_foil.png (831.04 KiB) Viewed 5451 times
Simon
--
Sales/Support

quelou
Posts: 2
Joined: Thu Jun 15, 2017 6:55 am

Re: can't patch from 1.07 to 1.08

Post by quelou » Wed Jul 19, 2017 8:44 am

it work

i built this for enter in the bootloader mode

Image
Image

so i can use my sunlite BC with the actual sofware ( 2017 ) on win7 and win10

thx

nick
Maxi Forumor
Posts: 274
Joined: Fri Feb 12, 2016 2:37 pm

Re: can't patch from 1.07 to 1.08

Post by nick » Tue Aug 01, 2017 3:12 pm

Hi,

Thank you for the photos of this method of triggering bootloader mode on interfaces that don't have bootloader pins on the PCB.

Another simpler method is to use aluminium foil which can be found in most kitchens.

Kind Regards,

Nick.
Attachments
bootloader pins2.jpg
bootloader pins2.jpg (41.13 KiB) Viewed 2191 times
Nicolaudie Tech Support

Post Reply