FC in Standalone - Scene stop running after a while

SLESA-U7 - SLESA-UE7 - SUITE2-FC

Moderators: simonB, nick, florent, dylan, Ben

Post Reply
hsteppke
Super Forumor
Posts: 101
Joined: Tue Jan 25, 2011 7:57 am

FC in Standalone - Scene stop running after a while

Post by hsteppke » Sun Jul 17, 2011 10:40 am

Hi,

i used the interface last weekend in standalone with a little board connected (Port1-8) to start 8 different Scence.
When a Scene was triggered after a while they stopped running .. some run 30 minutes some less then that.
I set them to "always loop" in Number of loops and nothing for the next scene.

It looks like that Scense that have longer EasyTime Programmes do run longer then Scence which shorter.(So my immediate question would be is there a max number of loops in the interface)

Any idea ? Is there a restriction in number of loops or is there a timer somewhere in need to change. Or do i have to give a Next Scene (would not make sence with always loop)


Regards
Holger

simonB
SuperMaxi Forumor
Posts: 1630
Joined: Thu Sep 17, 2009 1:50 pm

Re: FC in Standalone - Scene stop running after a while

Post by simonB » Tue Jul 19, 2011 9:00 am

Hi Holger

Always loop should loop forever. Check you're using the latest firmware and disable the infra red (in tools.exe). If it still doesn't work properly, send me your show and I will test on my suite2-FC here.
Simon
--
Sales/Support

Post Reply